How To Install Formica - icreatables.com

The 30-Second Trick For What kind of saw should I use on formica countertop? - Hometalk

Drill a starter hole inside the design template marks. The bit needs to be wider than the blade to your jigsaw. Screw a 12 (you can use the exact same piece you used for a rip fence if it is wider than the sink) to the center of your future hole. This will support the cut away so that its weight won't break any laminate when reaching the end of your cut.

Place the blade into your starter hole and begin cutting. Once again, constantly have the blade approximately full speed prior to initiating the cut.  Full Article  will find that it is a little harder to control a straight line with a jig saw however not to stress, the lip of the sink will cover any small slips over your mark.

Post-formed countertop (the kind with the essential backsplash and drip edge) fasts and easy to install-- as long as you do not need to suffice. Then it's awkward to deal with, the backsplash needs a different cut, and the plastic laminate chips easily. Commercial fabricators use big stationary saws with 12"- or 14"- dia.

Few people have that type of equipment, but you can get accurate results with a circular saw and a shop-built jig. The jig mimics the simple guide a lot of people utilize to cut plywood, however it has a 2nd (much shorter) leg that wraps around the backsplash. I developed my jig out of scrap 3/4" plywood and used some remaining 1/2"- thick crave the cleats that direct the saw.

DIY Laminate Countertops - Pink Little NotebookPink Little Notebook

Countertops 101: How to Cut Formica without a Hitch for Beginners

Then set up the cleat on the short leg of the jig and trim that side of the jig as well. Due to the fact that the edge of the jig is now perfectly aligned with the saw's blade, you place this edge on the counter top right on the line where you wish to make your cut.

Before making the backsplash cut, I set the counter top on sawhorses so it rests on the backsplash. This lets me make a nearly horizontal cut instead of trying to hold the saw vertically. (KEEP IN MIND: When cutting countertop, utilize a fine-toothed plywood cutting blade to minimize chipping in the plastic laminate.) As soon as you have actually got the backsplash cut, set the countertop on sawhorses and cut the broad area.